1. Low voltage detection sequence3.1V, 2.9V, 2.7V, not tested.
2: The startup modes are normal, soft, and enhanced in sequence.
3: The maximum braking force is sequentially (25A, 45A, 60A) 50%, 25%, 75%, and 100% (default 50%).
; ;NBSP (80A,120A)25%,50%,75%,100%(25%)
4: The maximum reversing strength is 25%, 50%, 75% and 100% respectively.
5: The width of the center point is 9%, 6%, and 12% respectively.
6: BEC cable connection is connected according to the color direction.
7: The red color of 1-5 above indicates the default settings of the electric shunting plant.
Programmer operation instructions:
a) Connect the BEC line of electric adjustment to the programmer, and the connection direction is in the color direction shown above (the black ground line is near the right frame).
b) Connect the power supply of the electrical regulator and turn on the power switch (80A and 120A should be held by pressing the electrical regulator button).
c) When the programming green LED on the programmer flashes twice, it is always on, indicating that the ESC and programmer are connected successfully. When the programming LED is off, it means that the programmer reads out the current programming parameters of the ESC and displays the corresponding LED in the corresponding project. Otherwise, the connection fails.
d) Press the down button on the programmer to select from different programming projects. The corresponding LED lights for the selected current project will light up in sequence, indicating the currently selected project.
e) Press the right button on the programmer to select the content that needs to be set in the currently selected project, and the content LED on the selection will light up.
f) Repeat the operations of d and e, select all the things that need to be set.
g) Press the programming button on the programmer to program the content set above onto the electrical control. The programming LED lights up at the beginning of programming and goes off after more than 5 seconds, indicating successful programming. Otherwise, the programming fails (after turning off the power, start programming again).
h) Press the factory button on the programmer to restore the ESC to factory default settings. Program at the beginning of programmingThe LED light comes on and goes off after more than 5 seconds, indicating successful programming. Otherwise, the programming fails (after turning off the power, start programming again).